Pressure Washer Pump for Himore, Husky, Ryobi 308653003, 308653045,

Product Description

• The ROP Shop replacement Pressure Washer Pump with Quick-Connect Plug & Coupler
• Specs - Pump - Max PSI: 2800. Max Flow: 2.3 GPM. Max RPM: 3400. Shaft Diameter: 7/8" Shaft. 3 Bolt Pattern: 7 11/16" x 6 3/16" x 6 7/16" & 4" Center to Each Outer Hole. Max Temperature: 140° F. Inlet Connection Type: Standard Garden Hose. Outlet Tube Connection: 22mm Male. Plug - Female Thread End: M22 (14mm). Plug End: 3/8". Max Temperature: 140° F (60° C). Coupler - Male Thread End: M22 (14mm). Female Coupler End: 3/8". Refer to images 2 & 3 for more information
• Includes - (1) Pressure Washer Pump with Chemical Injector, Unloader Valve, Thermal Release Valve, Outlet Tube, Hose, Keyway, (1) Quick-Connect Plug, (1) Quick-Connect Coupler; comes as shown in the first image
• This pump may require 1/2" spacers when installed, depending on motor configuration. Spacers are used in the case that the pump arm(s) hits the engine or can't reach the under side of frame such as the engine has a longer shaft. If spacers aren't used when installing, the pump legs will break from stress (spacers & longer bolts are NOT included). Brass outlet tube MUST be removed if quick-connect is being used
• This pump mounts vertical and is a rear facing (water inlets/outlets come out of the rear of the engine). Pump needs at least 5.5HP to handle PSI. Pump head can be flipped. Thermal relief valve comes pre-installed. This is a sealed unit, no oil maintenance required. Please note it is not recommended to run any pressure washer pump above its maximum PSI rating. Doing so can result in damage to the pump (not covered by warranty) and/or serious bodily injury